MHX 1568S x 600II with 1500mm infeed capabilities, and dual pressure feed rollers and pressure shoe at press infeed

Components

MF756A Infeed strap conveyor

Working table Length: 1550mm

Working table width: 600mmMotor power: 0.375kw 

MXZ3515S-II Auto finger shaper

Table size (LxW) 1500 x 600 mm

working size(L x W x H):1500 x 80 x 150mm

working size(L x W x H):150 x 30 x 20mm

Shaper spindle diameter:φ50mm Shaper blade diameter:φ160mm 20/20mm fingers

Main saw blade size:φ255mm Shaper spindle speed:5000 rpm

Main saw spindle speed:2840 rpm

FJ cutter spindle motor:22KW Main saw motor power:7.5KW

Working air pressure: 0.8 Mpa

Total power: 29.5KW

MF756B Middle strap conveyor

Working table Length: 1500mm

Working table width: 600mm

Motor power: 0.375kw

MXZ3515TS-II Auto finger shaper

Table size(W x L):1500 x 600 mm

working size(L x W x H):1500 x 80 x 150mm

working size(L x W x H):150 x 30 x 20mm

Shaper spindle diameter:φ50mm Shaper blade diameter:φ160mm 20/20mm fingers

Main saw blade size:φ255mm Shaper spindle speed:5000 rpm

Main saw spindle speed:2840 rpm

FJ cutter spindle motor: 22KW

Main saw motor power: 7.5KW

Working air pressure: 0.8 Mpa

Total power: 29.5kw

MF746 X20L Roller output conveyor,

MF761 Chain conveyor@2sets (Include 1 set MF762)

MHZ 1568 Auto finger joint assembler

working size(L x W x H):6700 x 150 x 80mm(1cycle can produce 2 workpieces)

working size(L x W x H):2000 x 30 x 20mm

Main saw blade size:φ405mm Working air pressure:0.8 Mpa

Jointing force: 7800kg Feeding reducer motor power: 1.5KW*4Pcs

Oil pump motor: 3Kw Saw motor power: 3kw

Total power: 12kw

Total Power required: 71 Kw

Timber specification requirements:

Only fully square-edged timber must be processed.

The thickness and width tolerances must not be larger than +/- 4 mm.

The timber sweep must not be larger than 2 mm/m width-wise.

The twist must not be larger than 2 mm/m length-wise.

The quality of the timber surface must ensure that the timber pieces pass each other easily at the package shaper (rough-sawn possible, if the grooves are not too deep).

There must not be any timber wane.

There must not be any knots in the finger jointed area.

The advertisement was translated automatically and some translation errors may have occurred.